TROUBLESHOOTING
■XM Satellite Radio
Error message | Cause | Remedy |
|
|
|
CHECK ANTENNA | The XM | Check the XM |
| accessory is not connected, or does not work | connections. |
| properly. |
|
|
|
|
UPDATING | The XM user encryption code is being updated. | Wait until the encryption code is updated. |
|
|
|
NO SIGNAL | The signal is too weak. | Check the XM |
|
| connections and orient it for the best reception. |
|
|
|
LOADING | It takes longer than four seconds for audio or | Wait until the decoding process has finished. |
| text data to be decoded. |
|
|
|
|
OFF AIR | The XM Satellite Radio channel you selected is | Check the channel number again or select another XM |
| not currently broadcasting any signal. | Satellite Radio channel. |
|
|
|
<XM> - - - | The channel station ID (SID) is no longer |
|
| available. |
|
|
|
|
- - | No artist name/feature or song/program title is |
|
| available. |
|
|
|
|
<CAT> - - - | No channels are available for the selected | Select another channel category by pressing CATEGORY on |
| category. | the front panel (or |
|
| repeatedly. |
|
|
|
■Remote control
Problem | Cause | Remedy | See | |
page | ||||
|
|
| ||
|
|
|
| |
The remote control | Wrong distance or angle. | The remote control will function within a maximum | 9 | |
does not work nor |
| range of 6 m (19.7 ft) and no more than 30 degrees | ||
function properly. |
|
| ||
|
|
|
| |
| Direct sunlight or lighting (from an | Reposition this unit. |
| |
| inverter type of fluorescent lamp, etc.) is |
| — | |
| striking the remote control sensor of this |
| ||
|
|
| ||
| unit. |
|
| |
|
|
|
| |
| The batteries are weak. | Replace all batteries. | 9 | |
|
|
|
| |
| The remote control ID and this unit’s ID | Switch the remote control ID or this unit’s ID. | 35, 36 | |
| do not match. |
| ||
|
|
| ||
|
|
|
| |
| The remote control code was not correctly | Try setting another code of the same manufacturer | 41 | |
| set. | using “LIST OF REMOTE CONTROL CODES” at | ||
|
| the end of this manual. |
| |
|
|
|
| |
| Even if the remote control code is | Use the supplied remote control for the components. | — | |
| correctly set, there are some models that |
| ||
| do not respond to the remote control. |
|
| |
|
|
|
|
44
