CONTROLS AND THEIR FUNCTIONS

■Battery installation

1

3

2

If you find that the remote control transmitter must be used closer to the main unit, the batteries are weak. Replace both batteries with new ones.

Notes

•Use only AA, R6, UM-3 batteries for replacement.

•Be sure the polarities are correct. (See the illustration inside the battery compartment.)

•Remove the batteries if the remote control transmitter will not be used for an extended period of time.

•If batteries leak, dispose of them immediately. Avoid touching the leaked material or letting it come in contact with clothing, etc. Clean the battery compartment thoroughly before installing new batteries.

DISPLAY PANEL

1

MEMO

9

1Multi-information display

Displays various information, for example station frequency, preset station number and name of selected input source.

2AUTO indicator

Lights up when this unit is in the automatic tuning mode.

3TUNED indicator

Lights up when turned in to a station.

4STEREO indicator

Lights up when an FM stereo broadcast with sufficient signal strength is received.

5CD DIRECT

Lights up when CD DIRECT is on.

■Remote control transmitter operation range

∞

Remote control

sensor

Within approximately 6 m (19.7 feet)

30

 

°

°

30

 

 

Notes

•There should be no large obstacles between the remote control transmitter and the main unit.

•If the remote control sensor is directly illuminated by strong lighting (especially an inverter type of fluorescent lamp etc.), it might cause the remote control transmitter not to work correctly. In this case, reposition the main unit to avoid direct lighting.

23 4 5

AUTO TUNED

STEREO

KHZ PURE CD

MHZ DIRECT DIRECT

SPEAKERS

SLEEP A B

8 7 6

6SPEAKERS A B indicator

Lights up according to which set of main speakers is selected. Both indicators light up when both sets of speakers are selected.

7SLEEP indicator

Lights up while the built-in SLEEP timer is functioning.

8PURE DIRECT

Lights up when PURE DIRECT is on.

9MEMO indicator

When the MEMORY button is pressed, this indicator flashes for about 5 seconds. While this indicator is flashing, the displayed station can be programmed to the memory by using the A/B/C/D/E button and the PRESET STATIONS buttons.

E-4