Yamaha RX-V2400 Starting the setup, English, SET MENU, PREPARATION, 2 Set PARAMETER/SET MENU to, 3Press k/nto select AUTO SETUP, DISTANCE, SIZE, EQUALIZING or LEVEL

Starting the setup

For best results, make sure the room is as quiet as possible during the auto setup procedure. If there is too much ambient noise, the results may not be satisfactory.

y

If your subwoofer can adjust the output volume and the crossover frequency, set the volume to about half way (or slightly less) and set the crossover frequency to the maximum.

1Switch on the receiver and video monitor.

Make sure the OSD is displayed.

2 Set PARAMETER/SET MENU to	PARAMETER
SET MENU.	SET MENU

3Press k/nto select AUTO SETUP,then press + once to enter the main menu.

SET MENU

. ;AUTO SETUP ;MANUAL SETUP

p/p	:	Up/Down
-/+	:	Select

4Press k/nrepeatedly to select WIRING,DISTANCE, SIZE, EQUALIZING or LEVEL.

1 AUTO:MENU

.
WIRING;;;;;CHECK

DISTANCE;;;CHECK

SIZE;;;;;;;CHECK

EQUALIZING;;FLAT

LEVEL;;;;;;CHECK

SETUP;;;;;;;AUTO


START PUSH +

p/p	:	Up/Down
-/+	:	Select

AUTO SETUP

5When WIRING, DISTANCE, SIZE or LEVEL is selected, press –/+ to select:

CHECK To automatically check and adjust the selected item.

SKIP To skip the selected item and perform no adjustments.

y

When using THX speakers, select SKIP and make sure that SMALL or SMLx2 is selected in SPEAKER SET (page 49) and that 80Hz is selected in CROSS OVER (page 50).

When EQUALIZING is selected, press –/+ to select:

FRONT To adjust the frequency response of each speaker in accordance with the sound of your front speakers.

Recommended if your front speakers are of much higher quality than your other speakers.

FLAT To average the frequency response of

	all speakers. Recommended if all of
	your speakers are of similar quality.
LOW	To average the frequency response of
	all speakers, giving priority to the
	accuracy of bass frequencies.
MID	To average the frequency response of
	all speakers, giving priority to the
	accuracy of mid-range frequencies.
HIGH	To average the frequency response of
	all speakers, giving priority to the
	accuracy of high frequencies.
SKIP	To skip the selected item and perform
	no adjustments.

6Press nto select SETUP, then press –/+ to select:

AUTO	To automatically perform the entire
	auto setup procedure.
STEP	To pause for confirmation between
	each check in the auto setup procedure.
RELOAD	To restore the last auto setup setting.

7Press nto select START PUSH +, then press +.

Loud test tones will be output from each speaker and WAIT appears during the auto setup procedure.

Note

If E-10:OTHER ERROR appears during testing, restart the procedure from step 3.

PREPARATION

English

25