Yamaha RX-V2400 Changing source names in the display window, 2Press RE-NAMEusing a, ballpoint pen or similar object, 3Press k/nto select and enter a character

REMOTE CONTROL FEATURES

6Press and hold the button you want to program on the other remote control until “OK” appears in the display window.

ENTER	TITLE	DTV	AUX-V	SYSTEM POWER	TRANSMIT
		1VCRDVR/VCR2CBL/SAT	R-CDMD/TAPETUNER	INCHMULTI	MACROLEARNCLEAR NAME-RE
				STANDBY
				POWER
	MODE INPUT	DVD	CD	PHONO	MACRO ON OFF

Notes

• “NG” appears in the display window if programming was

unsuccessful. In this case, start over from step 5.

• This remote control can learn approximately 120 functions.

However depending on the signals learned, “FULL” may

appear in the display before you program 120 functions. In this

Changing source names in the display window

You can change the name that appears in the display window on the remote control if you want to use the different name than the factory preset. This is useful when you have set the input selector to control a different component.

1Press an input selector button to select the source component you want to rename.

The selected component name appears in the display window.

				PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD
DTV	CBL/SAT	VCR 1	DVR/VCR2	DVD

2Press RE-NAME using a

case, clear unnecessary programmed functions to make room

for further learning.

ballpoint pen or similar object.

RE-NAME

7Repeat steps 5 and 6 to program additional functions.8Press LEARN again to exit from the learning mode.

LEARN

3Press k/nto select and enter a character.

Pressing nchanges the character as follows:

A to Z, a to z, 0 to 9, space, -(hyphen), and /(slash). (Pressing kchanges the characters in reverse order.)

ENTER

Notes

•Learning may not be possible in the following cases:

–When the batteries in the remote control for this unit or other components are weak.

–When the distance between the two remote controls is too great or too small.

–When the remote control infrared windows are not facing at the appropriate angle.

–When the remote control is exposed to direct sunlight.

–When the function to be programmed is continuous or uncommon.

•“ERROR” appears in the display window if you press more than one button at the same time.

4Press l/hto move the cursor to the next position.

ENTER

y

If you want to continue setting up names for other components, press ENTER and repeat steps 1, 3 and 4.

5Press RE-NAME again to exit from the renaming mode.

RE-NAME

62