LEARN
Notes
•The supplied remote control does not contain all possible manufacturer codes for commercially available AV components (including Yamaha AV components). If operation is not possible with any of the manufacturer codes, program the new remote control function with the Learn feature (see below) or use the remote control supplied with the component.
•If you have already programmed a remote control function for a button, the function by learning programming takes priority over the setup manufacturer code’s function.
•“ERROR” appears in the display window when press any buttons other than indicated in each step, or when you press more than one button at once.
Programming codes from other remote controls
If you want to program functions not included in the basic operations covered by the manufacturer code, or an appropriate manufacturer code is not available, do the following. You can program any of the buttons available in the component control area (see page 59). The buttons can be programmed independently for each component.
Note
This remote control transmits infrared rays. If the other remote control also uses infrared rays, this remote control can learn most of its functions. However, you may not be able to program some special signals or extremely long transmissions. (Refer to the operation instructions for the other remote control.)
| 1 Set 10KEY/DSP to 10KEY. | 10KEY DSP |
y
It is also possible to program in this unit’s control area with 10KEY/DSP set to DSP. However, if you do this, you will not be able to control this unit and select sound field programs.
2Press an input selector button to select a source component.
|
|
|
| PHONO |
TUNER | MD/TAPE | CD | ||
DTV | CBL/SAT | VCR 1 | DVR/VCR2 | DVD |
REMOTE CONTROL FEATURES
3Place this remote control about 5 to 10 cm apart from the other remote control on a flat surface so that their infrared transmitters are aimed at each other.
SOURCE | ENTER | TITLE | 1VCRDVR/VCR2CBL/SAT DTV | POWER | SYSTEM | MACROLEARNCLEAR |
| |
INCHMULTI |
| |||||||
|
|
|
|
| STANDBY |
|
|
|
|
|
|
|
| POWER |
|
|
|
|
| MODE INPUT | DVD | CD | PHONO |
| ON OFF | MACRO |
5 to 10 cm (2 to 4 inch)
4Press LEARN using a ballpoint pen or similar object.Do not press and hold LEARN. If you hold it down for more than three seconds, the remote enters the manufacturer code setting mode.
LEARN
Flashes alternately
y
Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press LEARN again.
5Press the button at which you want to program the new function.“LEARN” is displayed.
SOURCE | ENTER | TITLE | MODEINPUT | DVDDVR/VCR21 VCR CBL/SAT DTV | SYSTEM PHONOINCHMULTI | MACRO ONOFFMACROLEARN CLEAR | OPERATION | ADVANCED | |
|
|
|
|
|
| POWER |
|
|
|
|
|
|
|
|
| STANDBY |
|
|
|
|
|
|
|
|
| POWER |
|
|
|
English
61