Yamaha RX-V2400 Setting manufacturer codes, Component, source component you want to set up, 1Press an input selector button to select the

REMOTE CONTROL FEATURES

Setting manufacturer codes

You can control other components by setting the appropriate manufacturer codes. Codes can be set up for each input area.

The following table shows the default component (Library: component category) and the manufacturer code for each area.

	Component
Input area	category	Manufacturer
	(Library)

PHONO	TV	–

V-AUX	VCR	–

TUNER	TUNER	Yamaha-1

MD/TAPE	MD	Yamaha-1

CD-R	CD-R	Yamaha

CD	CD	Yamaha-1

DTV	TV	–

CBL/SAT	CABLE	–

VCR 1	VCR	–

DVR/VCR2	VCR	–

DVD	DVD	Yamaha-1

Note

You may not be able to operate your Yamaha component even if Yamaha manufacture code is initially set as listed above. In this case, try to set other Yamaha manufacture code(s).

1Press an input selector button to select thesource component you want to set up.

				PHONO
V-AUX	TUNER	MD/TAPE	CD-R	CD
DTV	CBL/SAT	VCR 1	DVR/VCR2	DVD

2Press and hold LEARN for about 3 seconds using a ballpoint pen or similar object.

“SETUP” and the selected component name appear alternately in the display window.

LEARN

Be sure to press and hold LEARN for at least 3 seconds, otherwise the learning process will start.

Complete each of the following steps in 30 seconds. Otherwise, the learning mode will be automatically canceled. In this case, press LEARN again.

3Press k/nto select the name of your component’s manufacturer.

You will find the names of most worldwide audio- video manufacturers in alphabetical order in the display window.

ENTER

If you want to change a library (component category), press l/h. You can set a different type of component.

Library choices: L:DVD, L:LD, L:CD, L:CDR, L:MD, L:TAP (tape), L:TUN, L:AMP*, L:TV, L:CAB (cable), L:DBS, L:SAT, L:VCR

*The amplifier Library (L:AMP) code is preset to “YPC” to operate this unit. However, you can switch between the following four codes if necessary.

YPC To operate this unit.

ZONE (U.S.A., Canada and Australia models only) To operate ZONE 2 or ZONE 3 features.

DSP To operate Yamaha DSP amplifiers that cannot be operated with the YPC code.

NO To operate other manufactures’ amplifiers using this unit’s remote control.

4Press one of the buttons shaded below to see if you can control your component. If you can, the manufacturer code is correct.

				INPUT MODE
		TITLE
			ENTER
SOURCE
	DISPLAY	MENU		SOUND
SELECT	SEARCH		– CHAPTER +
POWER	REC	STOP	PAUSE	PLAY

•If the manufacturer of your component has more than one codes, try each of them until you find the correct one.

•If you continuously want to set up another code for another component, press ENTER and repeat steps 1, 3 and 4.