Using the VIDEO AUX jacks on the front panel

Use the VIDEO AUX jacks on the front panel to connect a game console or a video camera to this unit. To reproduce the source signals input at these jacks, select “V-AUX” as the input source.

Caution

Be sure to turn down the volume of this unit and other components before making connections.

Notes

•The audio signals input at the DOCK terminal on the rear panel take priority over the ones input at the VIDEO AUX jacks.

•The audio signals input at the PORTABLE mini jack take priority over the ones input at the AUDIO L/R jacks.

Connecting the FM and AM antennas

Both FM and AM indoor antennas are supplied with this unit. In general, these antennas should provide sufficient signal strength. Connect each antenna correctly to the designated terminals.

Notes

•The AM loop antenna should be placed away from this unit.

•A properly installed outdoor antenna provides clearer reception than an indoor one. If you experience poor reception quality, install an outdoor antenna. Consult the nearest authorized Yamaha dealer or service center about outdoor antennas.

•The AM loop antenna should always be connected, even if an outdoor AM antenna is connected to this unit.

Outdoor AM antenna

AM loop

Use a 5 to 10 m (16 to 32 ft)

antenna

of vinyl-covered wire

(supplied)

extended outdoors from a

 

window.

 

Connections

Connecting the wire of the AM loop antenna

Open the

Insert

Close the

lever

 

lever

Assembling the supplied AM loop antenna

Note

•The types of the supplied AM loop antenna is different depending on the models.

Connecting the power cable

Once all connections are complete, plug the power cable into the AC wall outlet.

Power cable

L

PREPARATION

DEO

N DVR OUT

MONITOR

 

OUT

 

 

AUDIO

 

N

DVR

OUT

CD

 

 

ANTENNA

AM

GND

FM

75

UNBAL.

IN

MD/

(PLAY) CD-R

RSURRO

OUTP

OUT (REC)

Indoor FM antenna (supplied)

To the AC wall outlet

Turning on and off the power

Turning on this unit
Press ASTANDBY/ON (or dPOWER) to turn on this unit.

Ground

For maximum safety and minimum interference, connect the antenna GND terminal to a good earth ground. A good earth ground is a metal stake driven into moist earth.

y

•When you turn on this unit, there will be a 4 to 5-second delay before this unit can reproduce sound.

Set this unit to the standby mode
Press ASTANDBY/ON (or cSTANDBY) to turn off this unit.

Note

•In the standby mode, this unit consumes a small amount of power in order to receive infrared signals from the remote control.

English

15 En