Care and storage
EJU37145
Post-operation care
EWJ00330
WARNING
Always place the watercraft upright in a horizontal position when storing it, otherwise fuel could leak out into the engine or engine compartment, which could create a fire hazard.
After using the watercraft, always take it out of the water, clean it, and store it. Leaving the watercraft in the water for extended periods will accelerate the rate of normal deterioration of the jet pump and hull. Marine organisms and corrosion are some of the conditions that can shorten the life of many watercraft com- ponents.
EJU33547
Flushing the cooling water passages
ECJ01310
NOTICE
Do not run the engine over 4000 r/min on land. Also, do not run the engine for more than 15 seconds without supplying water, otherwise the engine could overheat.
Flush the cooling water passages to prevent them from clogging with salt, sand, or dirt.
(1)Place the watercraft in a horizontal posi- tion.
(2)Remove the seat. (See page 45 for seat removal and installation procedures.)
(3)Connect the garden hose adapter to a garden hose.
1
1 Garden hose adapter
(4) Loosen the flushing hose connector cap and remove it. Insert the garden hose adapter into the flushing hose connector and turn it until it is securely connected.
1
2 
3
1Garden hose adapter
2Flushing hose connector
3Flushing hose connector cap
(5)Connect the garden hose to a water tap.
(6)Make sure that the area around the wa- tercraft is clear, and then start the engine. Immediately after the engine starts, fully turn the water supply on so that water
78