¢QQQQQQQQQQQQQQ,,,,,,,,,,,,,,Setting¢¢¢Up¢¢¢¢¢¢¢¢¢¢

This section contains information about setting up your PSR-530 and preparing to play. Be sure to go through this section carefully before using your PSR-530.

Power Supply

Although the PSR-530 will run either from an optional AC adaptor or batteries, Yamaha recommends use of the more environmentally safe AC adaptor. Follow the instructions below according to the power source you intend to use.

•Never interrupt the power supply (e.g. remove the batteries or unplug the AC adaptor) during any PSR-530 record opera- tion! Doing so can result in a loss of data.

■Using An Optional AC Power Adaptor

zPlug an optional Yamaha PA-6 Power Adaptor into a wall AC outlet.

xThen plug the DC output cable from the PA-6 into the DC IN 10-12Vjack on the rear panel of the PSR-530. The internal batteries are automatically disconnected when an AC Power Adaptor is used.

DC IN 10-12V

PA-6

When turning the power OFF, simply reverse the procedure.

•Use ONLY a Yamaha PA-6 AC Power Adaptor (or other adaptor specifically recommended by Yamaha) to power your instrument from the AC mains. The use of other adaptors may result in ir- reparable damage to both the adaptor and the PSR- 530.

•Unplug the AC Power Adaptor when not using the PSR-530, or during electrical storms.

■Using Batteries

For battery operation the PSR-530 requires six 1.5V SUM-1, “D” size, R-20 or equivalent batteries.

When the batteries need to be replaced “LoBattry” may appear on top of the display, the volume may be reduced, the sound may be distorted, and other problems may occur. When this happens, turn the power off and replace the batteries.

Replace the batteries as follows:

zOpen the battery compartment cover located on the instrument’s bottom panel.

xInsert the six new batteries, being careful to follow the polarity markings on the inside of the compartment.

cReplace the compartment cover, making sure that it locks firmly in place.

•When the batteries run down, replace them with a complete set of six new batteries. NEVER mix old and new batteries.

•Do not use different kinds of batteries (e.g. alkaline and manganese) at the same time.

•If the instrument is not to be in use for a long time, remove the batteries from it, in order to prevent pos- sible fluid leakage from the battery.

•Plugging or unplugging the AC power adaptor while the batteries are in- stalled will reset the PSR- 530 to the defaults.

12