fall out. Take care not to lose these parts.

5.Clean the oil strainer with solvent.

6.Check the O-ring for damage and replace it if necessary.

7.Install the O-ring, oil strainer, compression spring and drain bolt. Tighten the engine oil

drain bolt to the specified torque.

ECB00320

CAUTION:

Before installing the engine oil drain bolt, be sure to install the O-ring, compression spring and oil strainer.

Tightening torque:

8Engine oil drain bolt:

32 Nm (3.2 m·kgf, 23.1 ft·lbf)

8.Add the specified amount of the recommend- ed engine oil, and then install and tighten the engine oil filler cap.

Recommended oil: See page 10-1.

Oil quantity:

1.25 L (1.32 US qt) (1.10 Imp.qt)

ECB00330

CAUTION:

●Do not use oils with a diesel specification of “CD” or oils of a higher quality than speci- fied. In addition, do not use oils labeled “EN- ERGY CONSERVING II” or higher.

●Make sure that no foreign material enters the crankcase.

9.Start the engine, and then let it idle for several minutes while checking it for oil leakage. If oil is leaking, immediately turn the engine off and check for the cause.

10.Turn the engine off, and then check the oil lev- el and correct it if necessary.

EBU27021

Transmission oil

The transmission oil level should be checked before each ride. In addition, the transmission oil must be changed at the intervals specified in the

8-12