Yeoman PR1145 instruction manual Lighting the Stove, Turning the Stove off, Upgrading the Stove

USER INSTRUCTIONS

2.Lighting the STOVE

2.1The control valve is on the right-hand side at the foot of the stove. It has two controls:

—The right-hand knob controls the pilot ignition

—The left-hand knob controls the main burner

2.2Refer to separate instructions if your stove is upgraded to include battery remote control. The following instructions apply whether or not you have the remote upgrade.

Lighting the Pilot

2.3The left-hand and right-hand control knobs must both point to off (•):

2

AR0914

2.4Press in the right-hand control knob and rotate anti-clockwise until a click is heard.

2.5Continue to press in. The knob should point to the pilot (). The pilot should now light.

2.6Keep the knob depressed for 10 seconds before releasing. The pilot should remain lit.

2.7If the pilot does not stay lit repeat the above steps.

NOTE: If the pilot goes out the Interlock system prevents it being lit again for a short period.

2.8If, after repeating the above steps, the pilot does not light, contact your retailer or installer.

Adjusting the Flame height

2.9Turn the right hand control to point to main burner ( ). You can now adjust the flame height and temperature using the left-hand control knob.

2.10Turn the left-hand knob anti-clockwise to increase the flame height.

2.11Turn clockwise to decrease the height.

YELLOW FLAMES APPEAR WHEN THE STOVE HAS REACHED SUFFICIENT HEAT (10 TO 20 MINUTES). IF THE STOVE IS EXTINGUISHED OR GOES OUT DURING USE WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT.

3.turning the Stove off

3.1To turn off main burner turn the left-handknob until it points to off (•). The pilot light will remain lit.

3.2To turn off pilot light press in and turn the right-handknob until it points to off (•). The pilot light will go out.

4.upgrading THE Stove

The stove is fitted with a control valve that can be upgraded to support a battery powered remote control. Two types of remote control can be obtained through your local Gazco stockist:

4.1The Standard Remote Control (Gazco Part No. 8455) controls the gas stove after the pilot is lit so you can regulate the main burner through its range of settings and turn the burner off leaving just the pilot lit.

4.2The Thermostatic and Timer Remote Control (Gazco Part No. 8456) controls the stove after the pilot is lit using three modes:

—Manual Mode – used to turn the burner on and off and regulate it through its range of settings.

—Auto Mode – used to turn the burner on and off and regulate the heat to a pre-set temperature.

—Timer Mode – used to turn the burner on and off at two pre-set times and regulate the heat to a pre-set temperature during those periods.

5