![](/images/new-backgrounds/1010023/1002329x1.webp)
SERVICING INSTRUCTIONS
SERVICING REQUIREMENTS/ FAULT FINDING CHARTS
1. SERVICING REQUIREMENTS
IMPORTANT – The glass panel on this appliance should be checked for any signs of damage on the front face of the glass panel (scratches, scores, cracks or other surface defects). If damage is observed, the glass panel must be replaced and the appliance must not be used until a replacement is installed. Under no circumstances should the appliance be used if any damage is observed. Please isolate the appliance until a replacement glass panel has been obtained and installed. Replacement glass panels can be purchased from Gazco via the retailer from which the appliance was purchased or any other Gazco distributor.
This appliance must be serviced at least once a year by a competent person. All tests must be serviced by best practice as described by the current Gas Safe recommendations.
1.1Before any test are undertaken on the appliance, conduct a gas soundness test for the property to ensure that there are no gas leaks prior to starting work.
1.2Before any tests are undertaken on the appliance it is also recommended to fully check the operation of the appliance.
1.3Special checks:
1.4Correct any faults found during the initial tests and then
1.5Advise the customer of any remedial action taken.
15mm | 3 |
| . |
| 5mm |
AR0097
CHECK 1
pilotassembly, clean the area. |
Yes
Does the pilot light? | No | Is the control being operated correctly? | Yes | Will the pilot light with a match? | No |
|
|
|
gas turned on to the appliance? | Yes | gas pressure correct? | |
|
| ||
Is the |
|
| Is the |
Yes | Has the system got any air in it? | |
|
|
No | point, | |
|
| |
|
| theinlet test filter. |
SYSTEM OK
IGNITION FUNCTIONAL
PILOT WILL NOT LIGHT
around the | short the spark, |
there is no debris | etc.) which could |
Ensure | (e.g. soot, |
Yes |
| No | |
|
|
|
|
the valve. | a spark? | Section retry. |
Operate | Is there | Consult 2 and |
|
|
|
No
Yes
Check alignment of pilot burner head, change the ignition lead, see Diagram 1 on page 14.
No |
|
| No |
|
|
|
|
|
|
|
|
|
|
|
Check isolation tap and gas meter, retry. |
|
|
| |
|
|
| ||
| Correct and retry. | |||
|
|
|
|
|
Yes
Purge the gas pipes and retry.
check and pilot |
in the system, seating, valve |
blockage the mag |
There is a |
SEE 'NO SPARK' CHART
15