SERVICING
REPLACING THE MOTOR & EFFECTS UNIT
8
Motor unit
Plug
AR2394
1.14The motor & effects unit is attached by 4 x screws located at the rear of the appliance. It may be necessary to move the appliance from its location to gain access to the rear of the stove. Remove the 4 screws on the lower rear casing.
Note: There are 2 x gaskets between the unit and the appliance. Remove and keep in a safe place.
1.15Disconnect the 2 x wires connecting the 2 x 'flying' LEDs to the front LED board, noting their orientation.
1.16Lift and rotate the motor unit to give access to the rear LED board.
1.17Disconnect both wires from the rear LED board, noting their orientation.
1.18Unplug the cables connecting the motor unit and the PCB.
1.19The motor and effects unit can now be removed and replaced as a whole unit.
1.20Replace in reverse order. Ensure to replace gaskets when reattaching motor to appliance body and that all wires are correctly connected.
REPLACING THE MIDDLE LED BOARD
The middle LED board is attached to the motor unit but can be replaced individually (see Diagram 9).
9Rear LED board
Middle LED board
AR2395
1.21Disconnect the wire connecting the middle LED board to the rear LED board, noting its orientation.
1.22Attach the new board and reconnect the wire.
REPLACING THE REAR LED BOARD
The rear LED board is attached to the motor unit but can be replaced individually (see Diagram 9).
1.23Remove the motor unit following instructions in 1.14 - 1.17 (it is not necessary to disconnect the motor unit from the PCB) and rotate to access the rear LED board.
1.24Release the board by removing the 2 x screws at either end of it.
1.25Disconnect the wire connecting the rear LED board to the front LED board, noting its orientation.
1.26Attach the new board using the 2 x screws and reconnect the wire.
1.27Replace motor and effects unit (see 1.14 - 1.20). Ensure to replace gaskets when reattaching motor to appliance body and that all wires are correctly connected.
11
