USER INSTRUCTIONS
How to Use these Instructions
The contents of Sections 1, 2 and 3 apply to all the models in our Electric Range.
The content of Section 4, Remove and Replace Door, gives different instructions for each model type.
Select the relevant information for your model.
1.important informAtion and
HEALTH AND SAFETY
ALL APPLIANCES DESCRIBED IN THESE INSTRUCTIONS ARE HEAVY. SEEK ASSISTANCE BEFORE UNLOADING AND LIFTING.
1.1Read all of the instructions carefully before using the appliance.
1.2Remove all packaging and dispose of at an appropriate recycling facility.
1.3To remove the protective packaging and fitting kit from inside a new appliance, choose the instruction corresponding to your model from Section 4.
1.4Do not locate this appliance immediately below a fixed socket outlet.
1.5The outer casing of this appliance is considered by the manufacturer to be a working surface which becomes hot when the fire is switched on. You must use a suitable fire guard to protect children, the elderly and the infirm.
1.6Do not use this appliance in the immediate surroundings of a bath, shower, swimming pool or any other area where the appliance could come into contact with water or humidity, e.g. a bathroom.
1.7
WARNING! DO NOT COVER
Do not allow the appliance to be covered or let the air inlet/outlet become obstructed as the appliance may overheat. Please note the warning symbol on the appliance (see above).
1.8For indoor use only. This appliance is not suitable for use outside the house.
1.9Keep the power cord away from hot surfaces and hot conditions. Do not route the power lead in front of the appliance.
1.10This appliance must stand on a clean, level, firm surface. Do not stand the fire on a carpet. Ensure that furniture, curtains etc. are positioned no closer than 1m and the fire stands on a surface that can withstand temperatures of 90°C for prolonged periods. Do not allow rugs to be placed within 500mm of the front of the stove.
1.11When the fire has been installed, the position of the plug must be accessible.
1.12Where the electricity supply cable has to pass through a fire place, stone surround etc. ensure suitable rubber bushes are fitted at possible wear points.
1.13If installed in an open fireplace, blank off the chimney to reduce the risk of a back draught which can cause the safety
1.14If the electricity supply cable is damaged do not use the appliance until it has been replaced. For safety reasons the replacement has to be carried out by Gazco, a Gazco service agent or a similarly competent electrician.
1.15Do not use this appliance with any kind of timer, programmer or thermal control or other device that will switch the appliance on or off automatically.
1.16The appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge, unless they are supervised or have been given instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance.
1.17Do not operate the appliance if it is damaged.
1.18Repairs of electrical appliances must only be performed by an electrical engineer. Should the appliance fail to operate, or in case of any damage, please contact the retailer from whom the appliance was purchased.
1.19Never leave the heater unattended while it is in use. Always switch the product to the OFF position and unplug it from the electrical outlet when not in use.
3
