T2 - 80 MINUTE SETTING
T3 - 110 MINUTE SETTING
(Factory Set Point)
T1 - 50 MINUTE SETTING
SHORTING PEGS TO
OVERRIDE TIMER
FOR SERVICE
MOVABLE JUMPER
WIRE TO CHANGE
DEFROST TIMER
FIG. 11 - AMBIENT MODIFIED TIME/TEMPERATURE CONTROL
SECURE OWNER'S APPROVAL: When the system is functioning properly, secure the owner's approval. Show him the location of all disconnect switches and the thermostat. Teach him how to start and stop the unit and how to adjust temperature settings within the limitations of the system.
MAINTENANCE
NORMAL MAINTENANCE
CAUTION: Prior to any of the following maintenance proce- dures, shut off all power to the unit to prevent per- sonal injury.
FILTERS - Inspect once a month. Replace disposable or clean permanent type as necessary. DO NOT replace permanent type with disposable. The dimensional size of the replacement filter must be the same as the replaced filter.
MOTORS
Outdoor fan motors are permanently lubricated and require no maintenance.
Indoor Blower Motor and Drive - The indoor blower motor features
CAUTION: Damage can occur if the bearings are overlubri- cated. Use grease sparingly.
WARNING:
Perform all maintenance operations on the blower motor with power disconnected from the unit. Do not attempt to lubricate bearings with the unit in operation.
On an annual basis, check the motor for accumulations of dust, etc. that may block the cooling slots in the motor shell. Check for loose, damaged or misaligned drive components. Check that all mounting bolts are tight. Replace defective parts as required.
If desired, every three years remove both pipe plugs at each end shell and clean out any hardened grease or foreign matter. Replace one plug on each end with a clean grease fitting. Using a low pressure grease gun, pump grease (Chevron
OUTDOOR COIL - Dirt should not be allowed to accumulate on the outdoor coil surface or other parts in the air circuit. Cleaning should be as often as necessary to keep coil clean. Use a brush, vacuum cleaner attachment, or other suitable means. If water is used to clean coil, be sure power to the unit is shut off prior to cleaning.
NOTE: Exercise care when cleaning the coil so that the coil fins are not damaged.
Do not permit the outdoor air discharge to be obstructed by overhanging structures or shrubs.
Unitary Products Group | 15 |