Philips HQ8270 manual Cleaning and maintenance, Cleaning the shaving unit in the Jet Clean System

English 15

3After trimming, close the trimmer (‘click’) and switch off the shaver (Fig. 20).

Cleaning and maintenance

Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the shaver and the Jet Clean System.

-- Clean the shaver after every shave for optimal shaving performance. -- The best and most hygienic way to clean the shaver is in the Jet Clean System.You can also rinse the shaver under the tap or clean it with

the brush supplied.

-- Be careful with hot water. Always check if the water is not too hot, to prevent your hands from getting burnt.

-- You can clean the outside of the shaver with a damp cloth.

Note:Water may leak from the socket at the bottom of the appliance when you rinse it.This is normal and not dangerous.

Cleaning the shaving unit in the Jet Clean System

The Jet Clean System cleans the shaving unit.

--

1

,,

2

3

Preparing the Jet Clean System for use

Fill the cleaning chamber before first use and when the ‘fluid low’ symbol flashes to indicate that the fluid level is too low. When the fluid level drops below the minimum level, the cleaning symbol and the ‘fluid low’ symbol start to flash with intervals and the holder returns to its starting position.  (Fig. 21)

Simultaneously press the release buttons on both sides of the cleaning chamber (1).Then lift the Jet Clean System off the cleaning chamber (2).  (Fig. 22)

The cleaning chamber remains behind.

Unscrew the cap from the bottle with HQ200 cleaning fluid and remove the airtight seal. 

Fill the cleaning chamber with HQ200 cleaning fluid up to the MAX indication (Fig. 23).