Philips HQ8260CC, HQ8290CC, HQ8270CC manual Using the Jet Clean System

16English

Note: Make sure the cleaning chamber is always filled above the MIN indication.

4Place the Jet Clean System back onto the cleaning chamber (Fig. 24).

Make sure that the release buttons snap back into place.

When the cleaning chamber is filled with cleaning fluid, do not move it to prevent leakage of cleaning fluid.

5Put the small plug in the Jet Clean System and put the adapter in the wall socket.

,, The holder automatically moves to the highest position.

The Jet Clean System is now ready for use.

Using the Jet Clean System

1Place the shaver upside down in the holder and push the lever

down completely to lock the shaver into place (Fig. 16).

,, The battery symbol on the Jet Clean System goes on to indicate that the shaver is being charged.

Note:The shaver cannot be placed in the Jet Clean System when the protection cap is on the shaving unit.

2Press the on/off button on the Jet Clean System to start the cleaning program.  (Fig. 25)

The cleaning program has two phases, the cleaning and drying phase. ,, The battery symbol on the Jet Clean System goes out.

,, During the first phase of the cleaning program, the cleaning symbol starts to flash and the shaver is automatically lowered into the cleaning fluid (Fig. 26).

,, The shaver automatically switches on and off several times and moves up and down.

,, The cleaning symbol flashes throughout the cleaning program, which takes 8 minutes.

,, During the second phase of the cleaning program, the shaver is placed in the drying position, indicated by a flashing drying symbol. This phase takes approx. 4 hours.The shaver stays in this position until the end of the program.  (Fig. 27)