INSTALLATION
SHIPMENT CONTENTS
Ensure all of the following parts are included in the package received from Z Mi- crosystems. Verify all parts have not been damaged during shipment. If any of the parts are missing or damaged, immediately contact Z Microsystems Customer Service at
•Command Console unit attached to the mounting plate
•Hardware kit
•Manual
•Power Supply Cable
•Video Signal Cable
•Serial I/O Cable
•CD of SoftMenu software
Remember to save the unit’s original shipping materials. It may be necessary to move the unit at a later date.
DANGER: To avoid shock hazard:
•Do not remove the covers around the Command Console.
•Do not connect or disconnect the Command Console during an electrical storm.
•The power cord plug must be connected to a properly wired and grounded power outlet.
•Any equipment to which the Command Console will be attached must also be connected to properly wired and grounded power outlets.
TOOLS REQUIRED
•Required Tools and Equipment
•Flathead screwdriver with about 10” shaft.
•Phillips screwdriver with about 10” shaft.
PRECAUTIONS
In preparation to install the Command Con- sole, take the following precautionary step:
Turn off the electrical power to your com- puter.
NOTE: For the fastest and easiest installation of the Command Console, follow these steps in the sequence they are presented.
6
Doc#