Zanussi ZUG 78 manual Getting Things Ready, Preparing Cabinet For Fitting Oven

INSTALLATION INSTRUCTIONS

This appliance must not be installed on a wooden base.

The dimensions given provide adequate air circulation around the unit within the cabinet, ensuring compliance with BS EN60-335.

Enquiries regarding the installation of the cooker point if required should be made to your Regional Electricity Company to ensure compliance with their regulations.

GETTING THINGS READY

PREPARING CABINET FOR FITTING OVEN

Make sure the cabinet is the correct size for the appliance to be fitted (Ref. Fig. 4).

If the size is between 605-610*mm, then the cabinet should be modified so that at the screw fixing points the recommended dimension of at least 600-605mm is maintained. The modification should ideally be localised to ensure that after screw fitment the oven is securely fixed into position.

The adjacent cabinets must be stable and firmly secured to the wall or floor. If necessary, make arrangements to ensure the work surface below which the oven will rest is level.

Mark the centre of the aperture into which the appliance is to be fitted onto the plinth board. Remove the plinth board from in front of the cabinets.

Cut the required ventilation slot in the plinth as detailed in Fig.5.

Drill two pilot screw holes into the sides of the adjacent cabinets, in the positions indicated by Fig. 4.

Fit the appliance mounting brackets using the two holes indicated in Fig. 6 to the adjacent cabinets ( Ref. Fig.4 & 7 )

Check that the mounting brackets are level. They can be adjusted if necessary by using the extra holes at the ends of the brackets. Once the brackets are level, drill a pilot hole through the central hole in the bracket and fit the remaining screw.

Fig.4

Fig.5

Fig.6

Fig.7

42