Zebra Technologies R110XiTM, R170XiTM manual 179

printer settings (continued) resynch mode, 58 RFID settings, 62 RFID tag type, 63 saving, 42

sensor type, 45

serial communications, 50 setting through front panel, 42 start print signal, 57

time, 59 verifier port, 56 ZPL mode, 53

printer setup checklist, 8 printhead

cleaning, 117

early warning message, 47 head close setting, 54

head resistor value setting, 56 head test count setting, 56 pressure adjustment, 39 when to clean, 116

product improvements, 149 proprietary statement, 149 protocol setting, 51

R

R110Xi

general specifications, 143 label specifications, 146 ribbon specifications, 145

R170Xi

general specifications, 144 label specifications, 146 ribbon specifications, 145 radiation exposure limits, 150

radio frequency information, 149 read power

change through front panel, 63 change using ZPL, 93

read RFID tag

read or write RFID format (^RF), 83 read RFID tag (^RT), 91

related documents, xii

relative humidity requirements, 10 remove used ribbon, 31

replace fuse, 122

report shipping damage, 9 reset network option, 61 reship the printer, 9 resynch mode setting, 58

return data to host computer (^HV), 80

Index

RFID

calibrate RFID tag from front panel, 63 calibrate RFID tag using ZPL (^HR), 78 change read power through front panel, 63 change read power using ZPL, 93 change write power through front panel, 63 change write power using ZPL, 93 create label formats, 69

display tag data, 64 enable motion, 85 error status, 63 guidelines, 65 LCD displays, 62

number of retries for block (^RR), 86 power settings, 68

RFID setup command (^RS), 87 RFID tag type, 63

RFID test, 62 “smart” labels, 15 transponder placement, 66

verify write operation (^WV), 97 when to perform calibration, 68 ZPL commands, 77

ribbon adhesive test, 17

create ribbon leader, 27 determining coated side, 16 load, 26

removal, 31

RIBBON IN message, 128 ribbon LED setting, 58 ribbon low warning, 47 Ribbon Out message, 127 scratch test, 17 specifications, 145 troubleshooting wrinkles, 131 when to use, 16

Ribbon S. setting, 58 ribbon sensor

calibration procedure, 50 cleaning, 119 location, 119 sensitivity calibration, 36 when to clean, 116

roll media loading, 21 routine maintenance, 115

RS-232 interface connections, 104 RS-422/RS-485 interconnections, 106 RTC (Real-time clock) setting

date, 59

idle display, 59 time, 59

23063L-003 Rev. 2 12/23/04 R110Xi/R170Xi User Guide 167