Zenith R40W46 warranty Programming the Remote to operate other devices

Programming the Remote to operate other devices

The remote control for your projection TV is a multi-brand or universal remote control. It can be programmed to operate most remote-controllable devices of other manufacturers.

Note that the remote control may not control all models of other brands.

1.Test your remote control.

To find out whether your remote control can operate the IR device without programming, turn on the IR device such as a VCR and press the corresponding mode button (VCR) on the remote control, while pointing at the IR device. Test the POWER and CH +/- buttons to see if IR device responds properly. If not, the remote requires programming to operate the device.

2.Turn on the IR device to be programmed, then press the corresponding mode button on the remote control.

3.Press the POWER and MUTE buttons simultaneously, the remote control is ready to be programmed for the code.

4.There are two ways to find the right code for the IR device.

A. If you press the CH +/- buttons repeatedly, the codes will change one at-a-time. Press the POWER button after each code change. If the right code is found, the device will turn off.

B. Enter a code number using the number buttons on the remote. Programming code numbers for the corresponding component can be found on the following pages. Again, if the code is correct, the device will turn off.

5.Press the EXIT button to store the code.

6.Test the remote control functions to see if the IR device responds properly. If not, repeat from step 2.

2

4

tv vcr cable dvd sat

mode light power

tv/video comp/dvi sleep

arc cc flashbk

1	2	3
4	5	6
7	8	9
video	0	audio
fcr		mute

vol ch

pip pipch- pipch+ swap

still pip input position mts

up

enter

leftright

menuexit

down

play pause stop record

rew ff

skip

3/4

3

4

5

33