If you are not prompted for a user name and password, do the following in this order: Recheck all connections; restart the modem and computer; and reset the modem by inserting a paper clip into the Reset pinhole in the center of the modem’s back panel and holding it for five seconds.
The user name and password you enter here do not serve the same purpose as any name and password that your Internet service provider may have given you.
3 The Zoom Configuration Manager opens and begins to automatically configure itself. This is evident because the Basic Setup page will open and quickly change to the Autodetect page. To specify your Internet service provider’s VPI and VCI settings, you must set the modem for manual configuration. Do the following:
aClick the Stop button to stop the modem from trying to automatically configure itself.
bSelect the Disable option button, then click Save Changes. The page changes, and the MANUALLY option button is selected.
cEnter the VPI and VCI settings into the appropriate boxes. These values should have been given to you by your Internet service provider.
dClick the Save Changes button, then click the Write Settings to Flash button.
4 Close Zoom Configuration Manager by closing your Web browser.
5 Change your computer’s TCP/IP settings from the values you specified in step 1 to those given to you by your Internet service provider. Besides changing the IP address, Subnet mask, and Default gateway values, you must enter an additional value: DNS. This, too, should have been provided by your Internet service provider. For more information about specifying these settings, see Chapter 3: Specifying TCP/IP Settings on page 15.
Continue with Testing Your Internet Connection on page 9.
14 | ADSL Bridge Modem User’s Guide |