Zoom HD16, HD8 No.2:08Beat03, Pattern, EOS

Reference [Rhythm]

ZOOM HD8/HD16 103

8. Repeatedly press the cursor right key to

move to the measure number for which

“EOS” is shown.

During step input, you can use the cursor left/right keys to

move the input position in measure units. When you reach the

end of the song, the indication “EOS” is shown on the second

line of the display.

HINT

• The REW [T] and FF [Y] keys in the transport section can be

used to move the current position in beat units.

•When “Event→” is shown on the display, turning the dial moves

the current position in sixteenth note units. By bringing up the

“Event→” indication to move to a point within a measure and

then using the cursor up/down keys to display event

information, you can enter event information in sixteenth note

units (→ p. 107).

9. Repeat steps 4 – 8 to enter all required

pattern information.

.When all required pattern information has

been entered, press the STOP [P] key.

The REC [O] key goes out and the rhythm song selection

screen appears again. If you press the PLAY [R] key, the

created rhythm song will be played.

To edit the entered rhythm pattern information, proceed as

follows.

●Selecting a different rhythm pattern

Use the cursor left/right keys to move to the point where the

respective rhythm pattern information is input, and then

turn the dial to select the new rhythm pattern.

By turning the dial at a point where no rhythm pattern

information is input (“←Pattern” is shown), you can add new

rhythm pattern information for this point.

In any case, the newly selected rhythm pattern information will

be valid until the point where the next rhythm pattern

information is input.

●Inserting a rhythm pattern in a song

Move to the point you want to insert the rhythm pattern, and

perform steps 4 – 7. A new rhythm pattern is inserted at the

current location, and all subsequent patterns are shifted

back by the duration of the inserted pattern.

●Erasing entered rhythm pattern information

Use the cursor left/right keys to move to the position of the

rhythm pattern information that you want to erase, and press

the [FUNCTION] key twice. This brings up the indication

“Event Erase?”. Then press the [ENTER] key. When

rhythm pattern information was erased, the previous pattern

will remain valid until the point where the next rhythm

pattern information is input.

●Deleting a speciﬁc measure

Use the cursor left/right keys to move to the start position of

the measure that you want to delete. Press the

[FUNCTION] key three times. This brings up the indication

“Measure Delete?”. Then press the [ENTER] key. The

measure at the current position is deleted, and subsequent

rhythm pattern information moves forward. When a

measure at the beginning of a rhythm pattern (for example

ﬁrst measure of a 2-measure pattern) is deleted, that

measure only is deleted, and the indication changes to

“←Pattern” for the second measure.

Pattern

No.2:08Beat03

Current position

Song

1 2

(measure number) 3

PATTERN 002 End of Song

çPattern

Pattern

EOS

End of Song

PATTERN 002

Current position

Song

1 2

(measure number) 3

Select pattern D

PATTERN A PATTERN B PATTERN C

PATTERN A PATTERN D PATTERN C

PATTERN A PATTERN B PATTERN C

PATTERN A PATTERN B

PATTERN D

PATTERN D PATTERN C

Insert

Delete

PATTERN A PATTERN B PATTERN C

PATTERN A PATTERN C