Zoom HD16, HD8 - page 81

Reference [Mixer]

ZOOM HD8/HD16 81

NOTE

• When a recording track is selected, the input signal is sent to

that track directly, without going through the track mixer.

Therefore the input track parameter setting has no effect.

However, the REC LVL parameter is always active, regardless of

the recording standby setting of a track.

•<< only>> The STEREO SUB-OUT jack parameters are

available only on the HD16.

4. To adjust the value of a numeric parameter,

turn the dial.

5. To change the setting of an On/Off parameter

(marked with an asterisk in the table), select

the parameter and then press the [ENTER]

key.

Each push of the [ENTER] key toggles the parameter between

On and Off. For example, when you switch HI EQ from On to

Off, the display indication changes as follows.

6. Repeat steps 3 – 5 until all desired

parameters are adjusted.

If required, you can use the cursor left/right keys, status keys

and [ON/OFF] keys in this condition to change to another

track/input and adjust other parameters.

7. To r eturn to the main screen, press the [EXIT]

key.

The row of parameter knobs above the faders and status keys

can be used to quickly adjust main track parameters.

NOTE

Only parameters for tracks 1 – 8 << 1 – 16>> and the

drum/bass track can be adjusted with the parameter knobs.

Master track and input parameters cannot be adjusted in this

way.

1. From the main screen, press the [SELECT]

key in the function/transport section.

You can now select a parameter for adjustment with the

parameter knob. The display shows the most recently adjusted

track parameter.

2. Repeatedly press the [SELECT] key, until the

parameter to adjust is shown.

The display shows the selected parameter.

The [SELECT] key gives access to the following track

parameters.

•EQ HI GAIN

•EQ MID GAIN

•EQ LOW GAIN

•CHORUS DELAY SEND LEVEL

•REVERB SEND LEVEL

•SUB-OUT SEND LEVEL << only>>

•PAN

The currently selected track parameter is also shown by the

parameter select indicator.

3. Turn the parameter knob for the track whose

setting you want to adjust.

The display switches to the track that is being adjusted, and the

value of the track parameter selected in step 2 changes.

HINT

You can also use the status keys to select a track. For the

drum/bass track, press the [RHYTHM] status key.

4. Repeat steps 2 – 3 for other parameters.

HINT

To change the setting of an On/Off parameter, select the

Using the parameter knobs

Track1

EQ HI G=0dB

Track1

EQ HI Off

"On" condition

"Off" condition

Track1

EQ HI G=-10dB

Track1

EQ MID G=-10dB

Track1

EQ MID G=-10dB

Track2

EQ MID G=-5dB