The display indication can be switched from number of samples to
HINT milliseconds. To do this, press the [SPECIAL] key after step 3.
STEP 4 | While listening to the loop playback of the sample, hit the [LOOP/MARK] pad at the point | ||
you want to designate as start point. |
|
| |
| The address of that point (or the time in milliseconds) is shown on the | [LOOP/MARK] pad | |
| display, and the new start point is set to this location. | LOOP/MARK | |
| It is also possible to use the [EDIT 1] wheel for setting the start |
|
|
| HINT point. Moving the wheel during loop playback sets the start point | BPM/VALUE |
|
|
|
| |
| to that location. For fine adjustment, hold down the [SOURCE] pad |
|
|
| while turning the [EDIT 1] wheel. | MEASURE | BEAT SAMPLE/SONG |
|
| ||
STEP 5 | Press the pad selected in step 3 to confirm the new start point. |
|
|
If necessary, the
Operation Mode Play Pad
To return the start point set with the [LOOP/MARK] pad to the HINT original position, press the [LOOP/MARK] pad again when
playback has stopped.
STEP 6 Press the [PAD FUNCTION] key.
The [PAD FUNCTION] LED goes out and the new start point is set.
FUNCTION
PAD
SONG
STEP 7 To modify the end point, press the [PAD FUNCTION] key and then pad 5 (END POINT).
The [PAD FUNCTION] LED and the LED of pad 5 are lit. |
| FUNCTION |
|
Pressing the [PAD FUNCTION] key and then pad 5 enables | PAD | 5 | END POINT |
|
| ||
the setting of the end point. | SONG |
| PRE COUNT |
|
|
Pressing the [BPM] key while setting the end point switches the HINT display to BPM units. This value is automatically calculated,
considering the passage from the start point to the end point as 4 beats.
Pressing the [BPM] key again switches back to normal display.
STEP 8 | Set the new end point, using the same procedure as described in steps 3 - 6. |
|
| ||
|
|
|
|
| |
STEP 9 | To modify the offset, press the [PAD FUNCTION] key and then pad 4 (OFFSET). |
|
| ||
|
| The [PAD FUNCTION] LED and the LED of pad 4 are lit. | FUNCTION |
|
|
|
|
| 4 |
| |
|
| Pressing the [PAD FUNCTION] key and then pad 4 enables | PAD | OFFSET | |
|
|
| |||
|
|
|
|
| |
|
| the setting of the offset. | SONG |
| SHIFT |
|
|
|
| ||
|
|
|
|
|
|
10 |
|
|
|
| |
STEP | Set the new offset, using the same procedure as described in steps 3 - 6. |
|
| ||
|
|
|
| ||
• All settings can only be made within the length range of the
NOTE
current sample.
•The start point cannot be set to fall after the end point, and the end point cannot be set to fall before the start point.
•The offset point cannot be set to fall outside of the range between start point and end point.
30