Zoom ST-224 Changing Song Settings

Changing Song Settings

The length of a song or the number of beats, the metronome sound volume, pre-count setting and other

song settings (song function parameters) can be changed, as follows.

EDIT 2 A EFFECT

B

ON/OFF

PAD ENABLE

EFFECT SYNC

EDIT 1

1
SOURCE	MIX
SOURCE

TAP BPM

AUTO SYNC

LEVEL	3
BARLENGTH
2	TUNING
	QUANTIZE

	MEASURE	BEAT	SAMPLE/SONG		RECORD PLAY/STOP
COPY	DELETE	–	+
EXIT		BACKUP			PAD ASSIGN CAPACITY ERASE OPTIMIZE
	LOAD	SAVE INTERNAL/DATA CARD SPECIAL
						FUNCTION
						PAD
						SONG
START POINT	5	END POINT	7
				REVERSE
TIME SIG		PRE COUNT					1
				CLICK VOLUME		BANK
4	OFFSET	6	PANNING
				8		BANK	2
	SHIFT				TRIGGER/GATE
			SWING
					MIDI		3
						BANK

LOOP/MARK

Songs Creating

STEP 1	In play mode, use the [-] [+] keys to select the song number (1 - 8).
	–	+
	[–] [+] keys
STEP 2	Press the [SONG FUNCTION] key.
	The [SONG FUNCTION] LED flashes.	FUNCTION
	PAD
	SONG

STEP 3	Select the item to be set, using pads 1 - 8.
	When the [SONG FUNCTION] key is pressed, the pads serve to
	select the parameters printed at the bottom right. When a pad is
	pressed, the [SONG FUNCTION] LED and the LED of the pad are
	constantly lit, and the setting of the respective parameter appears on
	the display. (For details on the song function parameters, see page
	53.)	BPM/VALUE
				MEASURE	BEAT SAMPLE/SONG
			Parameter		setting values
STEP 4	Use the [-] [+] keys or the [EDIT 1] wheel to change the setting.

STEP 5 Press the [SONG FUNCTION] key again.

The [SONG FUNCTION] LED goes out and the changed parameter is accepted. To cancel the parameter change, press the [EXIT] key instead of the [SONG FUNCTION] key.

Pads 1 – 8

– + EDIT 1

[–] [+] keys

[EDIT 1] wheel

FUNCTION

PAD

SONG

52