Zoom ST-224 Other Functions, Resetting the ST-224to the Factory Default (Initializing), Initializing Without Loading Backup Memory Data (Quick Start)

Other Functions

Resetting the ST-224 to the Factory Default (Initializing)

You can reset the unit to the factory default condition as follows.

PLAYLIST

				–	RECORD PLAY/STOP
EDIT 2	A EFFECT	TAP BPM			+
			COPY	DELETE
	B
	ON/OFF		EXIT	BACKUP	PAD ASSIGN CAPACITY ERASE OPTIMIZE
		AUTO SYNC		LOAD SAVE INTERNAL/DATA CARD	SPECIAL
	PAD ENABLE
					FUNCTION
	EFFECT SYNC				PAD
					SONG

STEP 1 Turn off the ST-224.

POWER

STEP 2 While holding down the [SAVE] key, turn the unit back on again.

The indication "init" appears on the display.		BACKUP
To cancel the initialization, press the [EXIT] key.	LOAD	SAVE INTERNAL/DATA CARD

POWER

STEP 3 Press the [SAVE] key again.

The ST-224 is reset to the factory default condition, and the preprogrammed sound sources (samples) are loaded into the main memory.

Proceed with care. When initialization is performed, all bulk data

NOTE stored in the backup memory will be erased.

BACKUP

LOAD SAVE INTERNAL/DATA CARD

Initializing Without Loading Backup Memory Data (Quick Start)

Normally, the ST-224 loads data from backup memory into the main memory every time the unit is turned on. This causes a certain delay until the unit can be used for playing or sampling. When wishing to skip this step and get the unit ready for use quickly, perform the following steps.

PLAYLIST

				–	RECORD PLAY/STOP
EDIT 2	A EFFECT	TAP BPM			+
			COPY	DELETE
	B
	ON/OFF		EXIT	BACKUP	PAD ASSIGN CAPACITY ERASE OPTIMIZE
		AUTO SYNC		LOAD SAVE INTERNAL/DATA CARD	SPECIAL
	PAD ENABLE
					FUNCTION
	EFFECT SYNC				PAD
					SONG

STEP 1 Hold down the [EXIT] key and turn the ST-224 on.

The ST-224 becomes ready for use immediately, because the loading	EXIT
process from backup memory is skipped. The main memory will be
empty.	POWER

Functions Other

69