Zoom ST-224 manual 65

•To store WAV files or AIFF files on a data card for the ST-224, a

NOTE computer capable of reading and writing MS- DOS format data cards is required.

•If "--" is shown in place of XX, the data card does not contain any of the files described above.

•When wishing to recall a preset sound, store the contents of the main memory and backup memory to a data card as required, and then reset the ST-224 to the factory default condition

( ➔ p. 69). By storing the present sounds on a data card, recalling of specific waveform data becomes possible. This is a handy feature.

STEP 3 Use the [-] [+] keys to select the file number (1 - 99).

•If "int" or "CArdXX" was selected in step 2 Proceed to step 4.

•If "FILEXX" or "AIFFXX" was selected in step 2 Proceed to step 5.

–+

[–][+] keys

STEP 4	If "int" or "CArdXX" was selected in step 2, press the [LOAD] key and use the [BANK 1] -
	[BANK 3] keys and pads 1 - 8 to select the load source bank number and pad number.

If "CArdXX" was selected in step 2, the bank number and pad number for the desired data within the bulk data must be specified before proceeding to step 5. When the [LOAD] key is pressed, the bank number (1 - 3) and pad number (1 - 8) for the source appear on the display. Specify the desired numbers here.

BPM/VALUE

BACKUP

LOAD SAVE INTERNAL/DATA CARD

BANK 1– 3 keys	Pads 1 – 8
BANK 1

MEASUREBEAT SAMPLE/SONG

Bank number

Pad number

STEP 5	Press the [LOAD] key and use the [BANK 1] - [BANK 3] keys and pads 1 - 8 to select the
	load target bank number and pad number.
	When the [LOAD] key is pressed, the bank number (1 - 3) and pad		BACKUP
		LOAD	SAVE INTERNAL/DATA CARD
	number (1 - 8) for the target appear on the display. Specify the
	desired numbers here.
	BPM/VALUE
		BANK 1– 3 keys		Pads 1 – 8
	MEASURE	BEAT SAMPLE/SONG
		BANK 1
		Bank number
		Pad number

STEP 6 To execute the loading process, press the [LOAD] key again.

If "int" or "CArdXX" was selected in step 2, the waveform data and	BACKUP
LOAD	SAVE INTERNAL/DATA CARD
pad parameters are loaded into the specified pad. If "FILEXX" or
"AIFFXX" was selected, waveform data only are loaded into the
specified pad.

When reading in a WAV file or AIFF file, the sampling frequency and HINT tuning parameters are automatically converted.

For details, see the section "ST-224 File Import Details" on page 72.

Data Reading and Storing

65