Connection to Sound Source (2) (Microphone)

Microphone

INPUT L/MONO

ZOOM CORPORATION MODEL

MADE IN JAPAN

LINE/MIC

R

L/MONO

PHONES

R

L/ MONO

 

INPUT

 

 

OUTPUT

 

To sample a signal from a microphone,

set the [LINE/MIC] switch to the "MIC"

LINE/MIC position.

 

L/MONO R

MIC/LINE

 

 

INPUT

 

 

 

 

INPUT

 

[INPUT] knob

300mAMIN

MAX

 

PEAK

 

 

[INPUT PEAK] LED

 

 

DATA CARD

MIDI IN

DC9V

POWER

Adjust the [INPUT] knob so that the [INPUT PEAK] LED on the front panel lights up during the loudest passages of the music.

Connected Getting

Adjusting the Volume

When connections have been established, adjust the volume as follows.

STEP 1

While power to the playback equipment is still off and the volume is set to minimum,

verify that all connections have been established correctly.

If cables are connected or disconnected while power to the playback equipment is on, or if power is turned on with the volume turned up, damage to the speakers may result.

STEP 2 Turn on power to the ST-224.

Connect the output cable of the supplied AC adapter to the [DC9V] jack on the ST-224, and set the [POWER] switch to ON.

AC Adapter

300mA

DC9V POWER

STEP 3 Turn on power to the playback equipment.

If the ST-224 is in the factory default condition, you can play preset sounds by tapping the pads. Hit pads 1 - 8 and adjust the [OUTPUT] knob on the ST-224 and the volume control on the playback equipment to obtain the desired volume (to initialize the unit to the factory default ➔ p.69).

Pads 1 - 8

OUTPUT

MINMAX

[OUTPUT] knob

9