Chapter 8 Network
Table 31 Network > TCP/IP (continued)
LABEL | DESCRIPTION |
IPv6 Settings | Click this to configure the following IPv6 settings. |
| Mode - |
| • Select Auto to have the Device use the IPv6 prefix from the connected router’s |
| Router Advertisement (RA) to generate an IPv6 address. |
| • Select Static if you have a fixed IPv6 address assigned by your ISP. |
| • Select Disable to not assign any IPv6 address for the NSA. |
| Address - Enter the IPv6 address assigned by your ISP. |
| Subnet prefix length - Enter the address prefix length to specify how many most |
| significant bits in an IPv6 address compose the network address. The range is 0 to 128 |
| Default Gateway - Enter the IP address of the |
| router or switch on the same segment as your Device's interface(s). The gateway helps |
| forward packets to their destinations. |
|
|
DNS | DNS (Domain Name System) is for mapping a domain name to its corresponding IP |
| address and vice versa. If you have the IP address(es) of the DNS server(s), enter |
| them. |
|
|
Dynamic | Select the option to have the NSA get a DNS server address automatically. |
|
|
Static | Select this option to choose a static DNS server address. Type the DNS server IP |
| address(es) into the fields below. |
|
|
Primary DNS | Type a primary DNS server IP address. |
Server |
|
|
|
Secondary DNS | Type a secondary DNS server IP address. |
Server |
|
|
|
HTTP (Web Configurator) | |
|
|
Enable Another Web | Select this to configure an additional HTTP port for accessing the web configurator. |
Configuration Port | Specify a number in the Port Number field. |
|
|
Jumbo Frames | Jumbo frames improve network performance. You must have a 1 Gbps (Gigabit |
| Ethernet) network that supports jumbo frames. Select the largest size of frame that all |
| of your network devices (including computer Ethernet cards and switches, hubs, or |
| routers) support. |
| When enabled, you can choose between 4 KB, 8 KB, and 9 KB frame sizes. |
| Note: If you enable jumbo frames on the NSA in a network that does not support them, |
| you will lose access to the NSA. If this occurs, you will have to restore the factory |
| default configuration. Push the RESET button on the NSA’s rear panel and |
| release it after you hear a beep. |
|
|
Network Diagnostic | Use this section to test the network connection to a particular IP address or domain |
Tool | name. Select an address or type it into the field. Then click Ping to have the NSA send |
| a packet to test the network connection. |
| • Successfully pinged host - The NSA is able to “ping” the host, the network |
| connection is OK. |
| • Unable to ping host - The NSA is able to “ping” the selected host. |
|
|
Apply | Click this to save your TCP/IP configurations. After you click Apply, the NSA restarts. |
| Wait until you see the Login screen or until the NSA fully boots and then use the NAS |
| Starter Utility to rediscover it. |
|
|
Reset | Click this to restore your previously saved settings. |
|
|
168 |
|
Media Server User’s Guide | |
|
|