ZyXEL Communications 56K manual Register Descriptions, Basic S-Registers ATSn=x

User's Guide for ZyXEL Omni 56K USB Modem

5.3S-Register Descriptions

In most bit-mapped S-registers, the default bit value is 0. Non-0 default values are followed by an asterisk. In some cases, default values are shown in the reference column preceded by +. Some bits are reserved for factory use and should not be changed.

5.3.1 Basic S-Registers "ATSn=x"

Table 24. Basic S-Registers “ATSn=x”

COMMAND	FUNCTION AND DESCRIPTION	+Ref.
S0=	Sets the number of rings on which the modem answers. 0 value	+000
	disables auto-answer.
S1=	Counts and stores number of rings from an incoming call.	+000
S2=	Defines escape code character, default ‘+’ (43 dec.). A value of 128 to	+043
	255 disables the escape code.
S3=	Defines ASCII Carriage Return.	+013
S4=	Defines ASCII Line Feed.	+010
S5=	Defines ASCII Backspace. A value of 128 to 255 disables the	+008
	Backspace key’s delete function.
S6=	Sets the number of seconds the modem waits before dialing if ‘X0’ or	+003
	‘X1’ is selected. If a setting of ‘X2,’ ‘X7’ is selected, the modem dials as
	soon as it detects a dial tone. This register also sets the time-out
	interval for the “W” dial modifier to wait for the dial tone. (See also
	S41b4.)
S7=	Sets duration, in number of seconds modem waits for a carrier.	+060
S8=	Sets duration, in seconds, for pause (,) option in Dial command and	+002
	pause between command re-executions for Repeat (>) command.
S9=	Sets duration, in tenths of a second of remote carrier signal before	+006
	recognition. (Ignored if in non-FSK or half-duplex operation.)
S10=	Sets duration, in tenths of a second, modem waits after loss of carrier	+007
	before hanging up.
S11=	Sets duration and spacing, in milliseconds of dialed Touch-Tones.	+070

Table 25. Extended S-Registers "ATSn=x"

COMMAND	Bit	dec	hex	FUNCTION AND DESCRIPTION	Ref.
S13=	Bit	dec	hex	Bit-mapped register.	+000
	1	2	2	Capture modem manufacturer information during
				V.42 handshake, can be displayed at ATI2 <Last
				Speed/Protocol> line if available (‘Flash’ or ‘ZyXEL’

5-22