Prestige 660RU-Tx Series User’s Guide

Figure 72 Menu 4 Internet Access Setup

Menu 4 - Internet Access Setup

ISP's Name= MyISP

Encapsulation= RFC 1483

Multiplexing= LLC-based

VPI #= 8

VCI #= 35

ATM QoS Type= CBR

Peak Cell Rate (PCR)= 0

Sustain Cell Rate (SCR)= 0

Maximum Burst Size (MBS)= 0

My Login= N/A

My Password= N/A

ENET ENCAP Gateway= N/A

IP Address Assignment= Static

IP Address= 0.0.0.0

Network Address Translation= SUA Only

Address Mapping Set= N/A

Press ENTER to Confirm or ESC to Cancel:

The following table contains instructions on how to configure your Prestige for Internet access.

Table 42 Menu 4 Internet Access Setup

FIELD

DESCRIPTION

 

 

ISP’s Name

Enter the name of your Internet Service Provider (ISP). This information is for

 

identification purposes only.

Encapsulation

Press [SPACE BAR] to select the method of encapsulation used by your ISP.

 

Choices are PPPoE, PPPoA, RFC 1483 or ENET ENCAP.

Multiplexing

Press [SPACE BAR] to select the method of multiplexing used by your ISP.

 

Choices are VC-based or LLC-based.

VPI #

Enter the Virtual Path Identifier (VPI) assigned to you.

 

 

VCI #

Enter the Virtual Channel Identifier (VCI) assigned to you.

 

 

ATM QoS Type

Press [SPACE BAR] and select CBR (Continuous Bit Rate) to specify fixed

 

(always-on) bandwidth. Select UBR (Unspecified Bit Rate) for applications that are

 

non-time sensitive, such as e-mail. Select VBR (Variable Bit Rate) for bursty traffic

 

and bandwidth sharing with other applications.

Peak Cell Rate

This is the maximum rate at which the sender can send cells. Type the PCR.

(PCR)

 

Sustain Cell Rate

Sustained Cell Rate is the mean cell rate of a bursty, on-off traffic source that can

(SCR)

be sent at the peak rate, and a parameter for burst-traffic. Type the SCR; it must be

 

less than the PCR.

Maximum Burst

Refers to the maximum number of cells that can be sent at the peak rate. Type the

Size (MBS)

MBS. The MBS must be less than 65535.

My Login

Configure the My Login and My Password fields for PPPoA and PPPoE

 

encapsulation only. Enter the login name that your ISP gives you. If you are using

 

PPPoE encapsulation, then this field must be of the form user@domain where

 

domain identifies your PPPoE service name.

Chapter 17 Internet Access

140