Prestige
Figure 121 Menu 21.x.1 TCP/IP Filter Rule
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1 | TCP/IP Filter Rule | ||
Filter Type= | |||
Active= No | 0 | IP | Source Route= No |
IP Protocol= | |||
Destination: IP Addr= |
| ||
| IP Mask= |
| |
| Port #= |
| |
| Port # Comp= None | ||
Source: IP Addr= |
| ||
| IP Mask= |
| |
| Port #= |
| |
| Port # Comp= None | ||
TCP Estab= N/A | Log= None | ||
More= No |
| ||
Action Matched= Check | Next Rule | ||
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
The following table describes how to configure your TCP/IP filter rule.
Table 55 Menu 21.x.1 TCP/IP Filter Rule
FIELD | DESCRIPTION |
|
|
Filter # | This is the filter set, filter rule coordinates, for instance, 2, 3 refers to the second filter |
| set and the third filter rule of that set. |
Filter Type | Use [SPACE BAR] and then [ENTER] to choose a rule. Parameters displayed for |
| each type will be different. Choices are TCP/IP Filter Rule or Generic Filter Rule. |
Active | Select Yes to activate or No to deactivate the filter rule. |
|
|
IP Protocol | This is the upper layer protocol, for example, TCP is 6, UDP is 17 and ICMP is 1. |
| The value must be between 0 and 255. A value of 0 matches ANY protocol. |
IP Source Route | IP Source Route is an optional header that dictates the route an IP packet takes |
| from its source to its destination. If Yes, the rule applies to any packet with an IP |
| source route. The majority of IP packets do not have source route. |
Destination: |
|
|
|
IP Addr | Type the destination IP address of the packet you want to filter. This field is ignored |
| if it is 0.0.0.0. |
IP Mask | Type the IP mask to apply to the Destination: IP Addr field. |
|
|
Port # | Type the destination port of the packets you want to filter. The field range is 0 to |
| 65535. A 0 field is ignored. |
Port # Comp | Select the comparison to apply to the destination port in the packet against the value |
| given in Destination: Port #. Choices are None, Less, Greater, Equal or Not |
| Equal. |
Source: |
|
|
|
IP Addr | Type the source IP Address of the packet you want to filter. A 0.0.0.0 field is ignored. |
|
|
IP Mask | Type the IP mask to apply to the Source: IP Addr field. |
|
|
183 | Chapter 22 Filter Configuration |