ZyAIR B-420 Wireless LAN Ethernet Adapter and Bridge

where “i” specifies binary image transfer mode (use this mode when transferring binary files), “host” is the ZyAIR IP address, “get” transfers the file source on the ZyAIR (rom-0 name of the configuration file on the ZyAIR) to the file destination on the computer and renames it config.rom.

The following table describes some of the fields that you may see in third party TFTP clients.

Table 13-3 General Commands for Third Party TFTP Clients

COMMAND

DESCRIPTION

 

 

Host

Enter the IP address of the ZyAIR. 192.168.1.11 is the ZyAIR’s default IP

 

address when shipped.

Send/Fetch

Use “Send” to upload the file to the ZyAIR and “Fetch” to back up the file on

 

your computer.

 

 

Local File

Enter the path and name of the firmware file (*.bin extension) or configuration

 

file (*.rom extension) on your computer.

 

 

Remote File

This is the filename on the ZyAIR. The filename for the firmware is “ras” and for

 

the configuration file, is “rom-0”.

 

 

Binary

Transfer the file in binary mode.

 

 

Abort

Stop transfer of the file.

 

 

13.3 Restore Configuration

Menu 24.6 – System Maintenance – Restore Configuration allows you to restore the configuration via FTP or TFTP to your ZyAIR. The preferred method is FTP. Note that this function erases the current configuration before restoring the previous backup configuration; please do not attempt to restore unless you have a backup configuration stored on disk. To restore configuration using FTP or TFTP is the same as uploading the configuration file, please refer to the following sections on FTP and TFTP file transfer for more details. The ZyAIR restarts automatically after the file transfer is complete.

Firmware and Configuraiton File Maintenance

13-5