ZyAIR B-420 Wireless LAN Ethernet Adapter and Bridge

Menu 24.7.2 - System Maintenance - Upload System Configuration File

To upload the system configuration file, follow the procedure below:

1.Launch the FTP client on your workstation.

2.Type "open" and the IP address of your system. Then type "root" and SMT password as requested.

3.Type "put configurationfilename rom-0" where "configurationfilename"

is the name of your system configuration file on your workstation, which will be transferred to the "rom-0" file on the system.

4.The system reboots automatically after the upload system configuration file process is complete.

For details on FTP commands, please consult the documentation of your FTP client program. For details on uploading system firmware using TFTP (note that you must remain on this menu to upload system firmware using TFTP), please see your manual.

Press ENTER to Exit:

Figure 13-6 Menu 24.7.2 System Maintenance : Upload System Configuration File

To transfer the firmware and the configuration file, follow these examples:

13.4.3 Using the FTP command from the DOS Prompt Example

Step 1. Launch the FTP client on your computer.

Step 2. Enter “open” and the IP address of your ZyAIR. Step 3. Press [ENTER] when prompted for a username.

Step 4. Enter “root” and your SMT password as requested. The default is 1234. Step 5. Enter “bin” to set transfer mode to binary.

Step 6. Use “put” to transfer files from the computer to the ZyAIR, e.g., put firmware.bin ras transfers the firmware on your computer (firmware.bin) to the ZyAIR and renames it “ras”. Similarly “put config.rom rom-0” transfers the configuration file on your computer (config.rom) to the ZyAIR and renames it “rom-0”. Likewise “get rom-0 config.rom” transfers the configuration file on the ZyAIR to your computer and renames it “config.rom.” See earlier in this chapter for more information on filename conventions.

Step 7. Enter “quit” to exit the FTP prompt.

13-8

Firmware and Configuraiton File Maintenance