|
| ZyAIR | |
|
| Table | |
|
|
|
|
| LABEL | DESCRIPTION |
|
|
|
|
|
| Peer Bridge | Type the MAC address of peer device in valid MAC address format, that is, six |
|
| MAC Address | hexadecimal character pairs, for example, 12:34:56:78:9a:bc. |
|
|
|
|
|
| WEP Encryption | Select Disable to allow wireless stations to communicate with the AP without any data |
|
|
| encryption. |
|
|
| Select |
|
| Authentication | Select Auto, Open System Only or Shared Key Only from the |
|
| Method | This field is N/A if WEP is not activated. |
|
|
| If WEP encryption is activated, the default setting is Auto. |
|
|
|
|
|
| ASCII | Select this option to enter ASCII characters as the WEP keys. |
|
|
|
|
|
| Hex | Select this option to enter hexadecimal characters as the WEP keys. |
|
|
| The preceding “0x” is entered automatically. |
|
|
|
|
|
| Key 1 to | The WEP keys are used to encrypt data. Both the AP and the wireless stations must |
|
| Key 4 | use the same WEP key for data transmission. |
|
|
| If you chose |
|
|
| characters |
|
|
| If you chose |
|
|
| characters |
|
|
| You must configure all four keys, but only one key can be activated at any one time. |
|
|
| The default key is key 1. |
|
|
|
|
|
| Enable | Select this check box to enable the Breathing LED, also known as the ZyAIR LED. |
|
| Breathing LED | The blue ZyAIR LED is on when the ZyAIR is on and blinks (or breaths) when data is |
|
|
| being transmitted to/from its wireless stations. Clear the check box to turn this LED off |
|
|
| even when the ZyAIR is on and data is being transmitted/received. |
|
|
|
|
|
| Output Power | Set the output power of the ZyAIR in this field. If there is a high density of APs within |
|
|
| an area, decrease the output power of the ZyAIR to reduce interference with other |
|
|
| APs. |
|
|
| The options are 11dBm (12.6mW), 13dBm (20mW), 15dBm (32mW) or 17dBm |
|
|
| (50mW). |
|
Wireless LAN |