Chapter 8 Wireless Screen
with other APs
Figure 80 Roaming Example
AP 1 | AP 2 |
Y
The steps below describe the roaming process.
1Wireless station Y moves from the coverage area of access point AP 1 to that of access point AP 2.
2Wireless station Y scans and detects the signal of access point AP 2.
3Wireless station Y sends an association request to access point AP 2.
4Access point AP 2 acknowledges the presence of wireless station Y and relays this information to access point AP 1 through the wired LAN.
5Access point AP 1 updates the new position of wireless station Y.
8.3.3.1 Requirements for RoamingThe following requirements must be met in order for wireless stations to roam between the coverage areas.
•All the access points must be on the same subnet and configured with the same
ESSID.
•If IEEE 802.1x user authentication is enabled and to be done locally on the access point, the new access point must have the user profile for the wireless station.
| 147 |
|
|