Chapter 22 Firmware
22.1.3 Firmware and Configuration Files Examples
This section contains examples about managing configuration files and uploading firmware to your
Using FTP to Restore Configuration
This example shows you how to restore a previously saved configuration. Note that this function erases the current configuration before restoring a previous back up configuration; please do not attempt to restore unless you have a backup configuration file stored on disk.
FTP is the preferred method for restoring your current computer configuration to your device since FTP is faster. Please note that you must wait for the system to automatically restart after the file transfer is complete.
Do not interrupt the file transfer process as this may PERMANENTLY DAMAGE your device. When the Restore Configuration process is complete, the device automatically restarts.
Restore Using FTP Session Example
Figure 72 Restore Using FTP Session Example
ftp> put config.rom
150 Opening data connection for STOR
226 File received OK
221 Goodbye for writing flash
ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit
Refer to Section 22.1.1 on page 151 to read about configurations that disallow TFTP and FTP over WAN.
FTP and TFTP Firmware and Configuration File Uploads
These examples show you how to upload firmware and configuration files.
Do not interrupt the file transfer process as this may
PERMANENTLY DAMAGE your device.
FTP is the preferred method for uploading the firmware and configuration. To use this feature, your computer must have an FTP client. The following sections give examples of how to upload the firmware and the configuration files.
| 153 |
|
|