Chapter 4 SHD2110/3110 Programming

4.2.1.4 Meter Report Command

The SHD2110/3110 will report its instant power consumption to Grouping 1. For detailed description of meter report command, refer to page 4.

4.2.2 Grouping 2

Grouping 2 includes the BASIC_SET commands. To control associated Z-Wave devices, the BASIC_SET command must be enabled. After receiving commands from the Z-Wave Controller, the SHD2110/3110 controls the on/off status of all devices associated in grouping 2. If you press the On/Off button on the SHD2110/3110, all devices associated will be turned on or off simultaneously.

4.2.2.1 Control Other Z-Wave Devices (Basic Set)

This enables or disables the BASIC_SET command. Refer to the Z-Wave’s Configuration section to configuration parameter 1 for the setting of basic set command.

Note: The SHD2110/3110 can associate with up to 4 SHD2110/3110s, acting as an active and passive device respectively. The active device cannot be set and controlled by passive one.

4.2.3 Z-Wave’s Configuration

The table below lists the configuration parameters and the value range for users to set up the SHD2110/3110.

Table 2 Z-Wave Configuration Table

PARAMETER

FUNCTION

SIZE (BYTE)

VALUE

UNIT

FACTORY

DESCRIPTION

DEFAULT

 

 

 

 

 

 

1

True Period

1

0~120

100ms

10

10x100ms=1 second

 

 

 

 

 

 

0: Disable

 

 

 

 

 

 

 

2

Send Basic

1

0.1

 

0

0:Disable

 

Command to

 

 

 

 

1:Enable

 

Group 2

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

3 (SHD3110

Meter Report

2

0-3240

10s

3

3x10=30 seconds

only)

Period

 

(9 Hours)

 

 

0:Disable

 

 

 

 

 

 

 

 

 

 

 

 

4.2.3.1 The True Period

If the True Period set to 10 seconds, pressing the On/Off button alternately within 10 seconds will not send out RF command. After 10 seconds, the SHD2110/3110 will examine if current On/Off state is the same as before. If it’s the same, no RF command will be sent, whereas if it is different, RF command will be sent to update the status. The maximum interval is 12 second (100ms*12=12000ms).

4.2.3.2 Send Basic Command to Grouping 2

If the Send Basic Command is set to 0, the SHD2110/3110 will not send out commands to other devices of Grouping 2 for On/Off operation if you press the On/Off button manually. If the setting is configured for 1, the SHD2110/3110 will send out commands to other devices of Grouping 2 for On/ Off operation.

18

 

Z-Wave Series Programming Guide