3
SHD1111 Programming
3.1 Z-Wave Group (Association Command Class Version 2)
The SHD1111 supports one association group with five nodes. When the SHD1111 is triggered, all devices associated with the SHD1111 will receive the relevant reports.
3.1.1 Tamper Event Report (Alarm Report)
Press and hold the tamper switch release it. The SHD1111 will send them there is a tamper event.
on the back of the SHD1111 for more than 10 seconds, then ALARM REPORT command to the nodes of Grouping 1 to inform
ALARM_REPORT Command
[Command Class Alarm, Alarm Report, Alarm Type = 0x01, Alarm Level = 0x11]
3.1.2 Control other Z-Wave Devices
When door/window is opened, the SHD1111 will send BASIC_SET command which contains an adjustable value to the nodes of Grouping 2. For instance, the brightness level of a lamp can be fixed according to the set value.
However, the BASIC_SET command will be also sent to the nodes of Grouping 1. For instance, a lamp module will be turned off after receiving the BASIC_SET command.
Basic Set Command
Event Present:
[Command Class Basic, Basic Set, Value = 255 (0xFF)]
Event Clear
[Command Class Switch Binary, Switch Binary Report, Value = 0x00(0)]
3.1.3 Z-Wave’s Configuration
3.1.3.1 Basic Set Level
The SHD1111 can send a Basic Set Command (set with a value) to a receiving device for the device to operate in a certain way. For instance, a lamp receives the Basic Set command which the value is decisive to the brightness (dim level) of this lamp.
The following parameters are used in this example:
| 13 |
|
|