ZyXEL Communications WAP3205 7.3 What You Need to Know, 7.3.1Setting your WAP3205 to Client Mode, 7.3.2 Accessing the Web Configurator in Client Mode

Chapter 7 Client Mode

7.3 What You Need to Know

With the exception of the Wireless LAN screens, the LAN, Monitor, Configuration and Maintainance screens in Client mode are similar to the ones in Access Point Mode. See Chapter 11 on page 101 through Chapter 12 on page 107 of this User’s Guide.

7.3.1Setting your WAP3205 to Client Mode

1Log into the Web Configurator if you haven’t already. See the Quick start Guide for instructions on how to do this.

2To set your WAP3205 to Client Mode, go to Maintenance > Sys OP Mode and select Client Mode.

Figure 25 Changing to Client mode

Note: You have to log in to the Web Configurator again when you change modes. As soon as you do, your WAP3205 is already in Client mode.

7.3.2 Accessing the Web Configurator in Client Mode

To login to Web Configurator in Client mode, do the following:

1Connect your computer to the LAN port of the WAP3205.

2The default IP address of the WAP3205 is “192.168.1.2”. If you did not change this, you can use the same IP address in Client mode. Open a web browser such as Internet Explorer and type “192.168.1.2” as the web address in your web browser.

If you changed the IP address of your WAP3205 while in Access Point mode, use this IP address in Client mode. The Client mode IP address is always the same as the Access Point mode IP adderss.

Note: After clicking Login, the Easy mode appears. Refer to Chapter 5 on page 35 for the Easy mode screens. Click Expert Mode to see the screens described in the sections following this.

54
	WAP3205 User’s Guide