Chapter 6 Wireless LAN

Note: WPS times out after two minutes of pressing a button. Press the button on the second device within about a minute of the first, then wait two minutes for the WPS configuration to complete.

To add the second wireless station, you have to press these buttons on both device and the wireless station again after the first 2 minutes.

Figure 33 Network > Wireless LAN > WPS Station

The following table describes the labels in this screen.

Table 17 Network > Wireless LAN > WPS Station

LABEL

DESCRIPTION

Config Mode

Use this to select Registrar or Enrollee mode. Select Registrar mode to make wireless

 

clients follow the wireless settings of the WRE2205. Select Enrollee mode to make the

 

WRE2205 follow the wireless settings of an access point.

 

 

Push Button

Use this button when you use the PBC (Push Button Configuration) method to configure

 

wireless stations’s wireless settings. See Section 5.2.1 on page 26.

 

Click this to start WPS-aware wireless station scanning and the wireless security

 

information synchronization.

 

 

Input station’s

Use this button when you use the PIN Configuration method to configure wireless station’s

PIN number

wireless settings. See Section 5.2.2 on page 28.

 

Type the same PIN number generated in the wireless station’s utility. Then click Start to

 

associate to each other and perform the wireless security information synchronization.

 

 

6.10 AP Select Screen

Use this screen to choose an access point that you want the WRE2205 to connect to. You should know the security settings of the target AP.

To open this screen, click Network > Wireless LAN > AP Select tab.

 

45

WRE2205 User’s Guide