Husqvarna CZ4815KAA, CZ4817KOA Before Starting the Engine, To Start Engine See Fig, ADD Gasoline

Page 16

OPERATION

BEFORE STARTING THE ENGINE

CHECK ENGINE OIL LEVEL

•The engine in your mower has been shipped from the factory, already filled with 10W-30 motor oil.

•Check engine oil with the mower on level ground.

•Refer to you Engine Owners Manual for correct oil level.

•To change engine oil, see the Customer Responsibilities section of this manual.

ADD GASOLINE

•Fill fuel tank. Use fresh, clean, regular unleaded gasoline with a minimum of 87 octane. (Use of leaded gasoline will increase carbon and lead oxide deposits and reduce valve life). Do not mix oil with gasoline. Purchase fuel in quantities that can be used within 30 days to ensure fuel freshness.

IMPORTANT: WHEN OPERATING IN TEMPERATURES BELOW 32° F. (0° C.), USE FRESH, CLEAN WINTER GRADE GASOLINE TO HELP INSURE GOOD COLD WEATHER STARTING.

CAUTION

Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids dur- ing storage. Acidic gas can damage the fuel system of an engine while in storage. To avoid engine problems, the fuel system should be emptied before storage of 30 days or longer. Drain the gas tank, start the engine and let it the run until the fuel lines and carburetor are empty. Use fresh fuel the next season. See Storage Instruc- tions for additional information. Never use engine or carburetor cleaners in the fuel tank or permanent damage may occur.

WARNING

Fill to bottom of filler neck. Do not over fill. Wipe off any spilled oil or fuel. Do not store, spill or use gasoline near an open flame.

TO START ENGINE (See Fig. 3)

When starting the engine for the first time or if the engine has run out of fuel, it will take extra cranking time to move fuel from the tank to the engine.

•Be sure IZT (Integrated Zeroturn Transaxle) bypass linkages are in the drive position.

•Sit on the seat in the operators position, release park brake lever.

•Check to be sure the PTO switch is disengaged.

•Move the throttle control to the choke position.

•For a warm engine start, the choke control may not be needed

16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 968999219 / CZ4815KAA 968999220 / CZ4817KOATechnical Assistance Contents Safety Rules General OperationII. Slope Operation Safe Operation Practices for RIDE-ON MowersIII. Children III. ServiceSafe Operation Practices for RIDE-ON Mowers Do not Safety Rules Specifications Customer ResponsibilitiesAssembly Tools Required For AssemblyTo Remove the Mower from Crate Before Removing Mower from the SkidControl Lever ARM HEX Bolts Neutral Slot Checklist Check the Tire PressureOperation ControlsDeck Blades HOW to USE Your MowerEngine To Adjust the Deck Cutting Height See Fig To Adjust ANTI-SCALP Rollers See FigureTo Operate Mower To Operate on HillsTo Transport See Fig Before Starting the Engine To Start Engine See FigCheck Engine OIL Level ADD GasolineMowing Tips General Recommendations Before Each USELubrication Chart Operator Presence SystemBlade Care TiresBattery To Sharpen Blade See FigEngine BeltsLubrication Clean AIR Screen Clean AIR INTAKE/COOLING AreasAIR Filter Engine OIL FilterCleaning Mower Service and AdjustmentTo Level Deck FRONT-TO-BACKADJUSTMENT See Fig To Replace Deck BeltTo Replace IZT Integrated Zeroturn Transaxle Belt See Fig To Adjust the Seat See Fig To Adjust Control Levers See FigTo Start AN Engine with a Weak Battery To Remove Wheels for RepairTo Adjust Park Brake To Attach Jumper CablesTracking Adjustment Battery StorageFuel System Engine OILOther CylindersTroubleshooting Points Problem Cause CorrectionProblemcausecorrection Wiring Schematic
Top Page Image Contents