Safety equipment
6.9Dismantling the throttle control lock, throttle control and spring
1
Loosen the screw on the rear handle. Remove the handle insert (A). See figure 19.
A
Fig 19
2
Loosen the throttle control lock (B) as shown in the figure using a screwdriver or similar tool. Remove it then from the shaft in the handle. See figure 20.
3
Press out the throttle control pin (C) with the help of a punch. See figure 21.
4
Loosen the throttle cable (D) and lift out the throttle control and the spring. See figure 22.
5
Cleaning and inspection
• Carefully clean and check all parts. See figure 13. Parts must be replaced if cracked or show signs of other defects. Always use original spare parts.
• Check that the spring is intact and retains all its tension.
22 - English
Fig 20
Fig 21
Fig 22
Fig 23