Husqvarna 966451906 manual Safety equipment

6.10Assembling the throttle control lock, throttle control and spring

1

Lubricate the pin and joined surfaces with a light oil. Hook on the throttle cable (D). Slide in the throttle control and make sure the spring is fitted as outlined in figure 24.

NOTE! Make sure that the rear end of the throttle control is correctly aligned inside the cut-out edg- ing before the pin is pressed in place.

2

Fit the throttle control’s pin (C) using a punch. See figure 25.

Fig 24

C

Fig 25

3

Fit the throttle control lock (B) by sliding it on the shaft in the handle. See figure 26. Make sure the spring is positioned inside the throttle control lock when you press it down so that the barbs are hooked in place.

4

Fit the handle insert using a screw, when the throttle control, spring, throttle cable and throttle control lock with pin are fitted correctly.

Fig 26