Repair Instructions
7 Repair instructions
7.1 Dismantling the starter
1
Loosen the four screws, which hold the starter against the crankcase and remove the starter.
2
Pull the cord out about 30 cm and lift it into the notch on the outside of the starter pulley. Release the tension in the return spring by letting the starter pulley rotate
WARNING!
If the spring tension is activated 
on the starter pulley, the spring
can fly out and cause personal injury. Wear protective glasses.
Fig 1
Fig 2
3
Loosen the screw in the centre of the pulley and remove the pulley. See figure 3. Loosen the screws on the cassette and remove the cassette and spring.
Cleaning and inspection Clean the parts and check:
• The starter cord.
• That the starter pawls on the flywheel are intact, i.e. that they spring back to the centre and move easily.
• To lubricate the return spring using light oil.
Fig 3a
English - 25