Husqvarna SG13A / CE, 968999239 manual Operating

Page 10

SAFETY INSTRUCTIONS

Operating

DO NOT use the machine on grades of more than 10°.

DO NOT use the machine if you are tired, if you have consumed alcohol, or if you are taking other drugs or medication that can affect your vision, judgment or coordination.

Never use the machine indoors or in spaces lacking proper ventilation.

Make sure you have a proper foothold when using the machine, particularly when backing. Walk, don’t run. Never work on wet grass. Poor traction may cause you to slip.

Keep your hands and feet away from moving parts.

Keep your hands and feet away from the work tools.

DO NOT use your feet or other parts of your body to gain greater bearing pressure against the stump.

Smoking, open flames or sparks in the vicinity of the machine are strictly forbidden. Gasoline is extremely flammable and carelessness in handling can result in personal injury or fire.

Never use a machine with a defective muffler.

In very warm and dry climates, stump grinder operation poses a risk of forest fires.

Stop and inspect the equipment if you run over or into anything. If necessary, make repairs before beginning again.

Whatever happens, you should always park the machine on even ground, disengage the drive, activate the parking, turn off the engine and wait until all moving parts have stopped before leaving the operating position behind the machine.

8011-209chg

The engine exhaust is poisonous. Never run the engine indoors.

8011-091

Make sure you keep your hands and feet away from moving parts.

8011-291chg

Smoking near the machine is strictly prohibited.

WARNING!

Engine exhaust, some of its constituents and certain vehicle components contain or emit chemicals considered to cause cancer, birth defects or other reproductive harm. The engine emits carbon monoxide, which is a colorless, poisonous gas. Do not use the machine in enclosed spaces.

10

Image 10
Contents Operator’s Manual Model 968999239 Manual no REV 03/08/04Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsDecal Important information Location of decals Translation of instructionsDecal Safety Instructions General useSafety Instructions Preparations Operating Storage Movement/TransportChildren Fuel system Maintenance Protective Equipment Personal equipmentSET-UP Equipment set-upHair PIN Engine Presentation ControlsMain components and operating controls Throttle Engine12 11 Fuel valve StarterStarter handle Choke controlOil dipstick Spark plugMuffler Oil drainageCentrifugal clutch Fuel tankFueling Dead man’s grip barBrake On/Off Engine switch on the panelAdjustment bar for the handle Never operate a machine with a defective brakeOperation Starting the engineDead man’s grip bar Engine switch on the handleStarter handle Shutdown in emergency situations Engine switchNormal shutdown BrakeBefore you start Using your stump grinder 8011-202chg Operating on hills Shut off the machine when you are doneTransport Maintenance Maintenance scheduleCleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Cleaning and washing Adjusting the brakeTwo minute rule Lubrication Blade shaft bearingsEngine oil Checking the engine’s oil levelRight wheel Throttle cableTroubleshooting Symptom Cause ActionProblem Possible solutions Storage ServiceWinter storage Technical Data ModelWiring Diagram Service Journal Delivery serviceService Journal