Husqvarna 968999239, SG13A / CE manual Before you start

Page 27

OPERATION

Before you start

Dig away the earth and remove any stones near the tree stump that may interfere with your work. Check that the ground is free of foreign objects, such as electrical cables, barbed wire, etc.

Cut or trim the stump as necessary using a power saw.

Review all of the machine’s safety decals.

Use a hard hat, ear and eye protection. A mesh visor alone does not provide sufficient eye

protection; supplement with protective glasses.

Make sure that you are familiar with safety regulations and shutdown procedures described previously in the operator’s manual.

Make sure that all guards are in place and in good condition.

Make sure that the blades and cutters are in place and in good condition.

Make sure that the work area and cutter in particular and free from metallic objects such as wire, nails, etc. that could be thrown out and injure persons in the vicinity and damage the equipment.

Make sure that everyone, including children and animals, maintains a distance of at least 50 feet (15 M) from the machine. Debris can be thrown

out and injure people and animals.

8011-141

8011-191

8011-193

8011-192chg

27

Image 27
Contents Manual no REV 03/08/04 Operator’s Manual Model 968999239Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsLocation of decals Translation of instructions Decal Important informationDecal General use Safety InstructionsSafety Instructions Preparations Operating Movement/Transport StorageChildren Fuel system Maintenance Personal equipment Protective EquipmentEquipment set-up SET-UPHair PIN Engine Controls PresentationMain components and operating controls Engine Throttle12 11 Choke control StarterStarter handle Fuel valveOil drainage Spark plugMuffler Oil dipstickDead man’s grip bar Fuel tankFueling Centrifugal clutchNever operate a machine with a defective brake On/Off Engine switch on the panelAdjustment bar for the handle BrakeStarting the engine OperationEngine switch on the handle Dead man’s grip barStarter handle Brake Engine switchNormal shutdown Shutdown in emergency situationsBefore you start Using your stump grinder 8011-202chg Shut off the machine when you are done Operating on hillsTransport Maintenance schedule MaintenanceCleaning the cyclone filter Replacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Cleaning and washingTwo minute rule Blade shaft bearings LubricationChecking the engine’s oil level Engine oilThrottle cable Right wheelSymptom Cause Action TroubleshootingProblem Possible solutions Service StorageWinter storage Model Technical DataWiring Diagram Delivery service Service JournalService Journal