Husqvarna SG13A / CE, 968999239 Controls, Presentation, Main components and operating controls

Page 18

CONTROLS

Presentation

Congratulations on your choice of an exceptionally high quality product. This operator’s manual describes the Husqvarna stump grinder.

The machine is equipped with a 13 hp Honda four- cycle engine.

Main components and operating controls

		8		9
	5
6
				10
				11
4		8	3
			3	2
	5			2
	5	7		1
		7		1

1.	Handle	7.	Engine
2.	Dead man’s grip bar	8.	Rear lifting handle
3.	Brake lever	9.	Adjustment bar for the handle
4.	Belt guard for the cutter drive	10.	Throttle
5.	Front lifting handle	11.	Engine switch
6.	Cutting wheel

18

Image 18

Contents Operator’s Manual Model 968999239 Manual no REV 03/08/04Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Symbols and Decals Decals and machine-bound instructionsLocation of decals Translation of instructions Decal Important informationDecal Safety Instructions General useSafety Instructions Preparations Operating Movement/Transport StorageChildren Fuel system Maintenance Protective Equipment Personal equipmentSET-UP Equipment set-upHair PIN Engine Controls PresentationMain components and operating controls Engine Throttle12 11 Fuel valve StarterStarter handle Choke controlOil dipstick Spark plugMuffler Oil drainageCentrifugal clutch Fuel tankFueling Dead man’s grip barBrake On/Off Engine switch on the panelAdjustment bar for the handle Never operate a machine with a defective brakeOperation Starting the engineEngine switch on the handle Dead man’s grip barStarter handle Shutdown in emergency situations Engine switchNormal shutdown BrakeBefore you start Using your stump grinder 8011-202chg Shut off the machine when you are done Operating on hillsTransport Maintenance Maintenance scheduleCleaning the cyclone filter Replacing the air filter Cleaning the sludge reservoir Idle adjustmentIgnition system Fitting the wrong spark plug type can damage the engineAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Adjusting the brake Cleaning and washingTwo minute rule Lubrication Blade shaft bearingsEngine oil Checking the engine’s oil levelRight wheel Throttle cableTroubleshooting Symptom Cause ActionProblem Possible solutions Service StorageWinter storage Technical Data ModelWiring Diagram Service Journal Delivery serviceService Journal