Husqvarna 968999239, SG13A / CE Engine switch on the handle, Dead man’s grip bar, Starter handle

Page 25

OPERATION

Engine switch on the handle

Set the toggle switch to ON.

Dead man’s grip bar

Hold in the bar for the dead man’s grip against the handle.

8011-185

Starter handle

The dead man’s grip must be pressed in when starting the engine.

Misuse of the starter handle can damage the starter. DO NOT twist the starter cord around your hand.

Pull out the handle slowly until the gears mesh. Then give a sharp pull on the starter handle. DO NOT pull out the starter cord completely and DO NOT let go of the starter handle when extended.

Throttle

Keep the throttle at idle. When the throttle is increased, the cutting wheel will begin rotating.

8011-127

25

Image 25

Contents Manual no REV 03/08/04 Operator’s Manual Model 968999239Husqvarna All Rights Reserved Printed Beatrice, Nebraska Table of Contents Introduction Decals and machine-bound instructions Symbols and DecalsDecal Important information Location of decals Translation of instructionsDecal General use Safety InstructionsSafety Instructions Preparations Operating Storage Movement/TransportChildren Fuel system Maintenance Personal equipment Protective EquipmentEquipment set-up SET-UPHair PIN Engine Presentation ControlsMain components and operating controls Throttle Engine12 11 Starter handle StarterFuel valve Choke controlMuffler Spark plugOil dipstick Oil drainage Fueling Fuel tank Centrifugal clutch Dead man’s grip barAdjustment bar for the handle On/Off Engine switch on the panelBrake Never operate a machine with a defective brakeStarting the engine OperationDead man’s grip bar Engine switch on the handleStarter handle Normal shutdown Engine switchShutdown in emergency situations BrakeBefore you start Using your stump grinder 8011-202chg Operating on hills Shut off the machine when you are doneTransport Maintenance schedule MaintenanceCleaning the cyclone filter Replacing the air filter Idle adjustment Cleaning the sludge reservoirFitting the wrong spark plug type can damage the engine Ignition systemAdjusting the drive belt Disassembling and reassembling the blade, pockets and teeth Removing and refitting the wheels Cleaning and washing Adjusting the brakeTwo minute rule Blade shaft bearings LubricationChecking the engine’s oil level Engine oilThrottle cable Right wheelSymptom Cause Action TroubleshootingProblem Possible solutions Storage ServiceWinter storage Model Technical DataWiring Diagram Delivery service Service JournalService Journal